Yak 54 103"

Photos
Features
Specs
Notes
ManualAdobe Acrobat
Video Coming Soon!
Magic Hand - YAK 54






35% 103" Magic Hand YAK-54 ARF
This plane is designed and built around the DA-85! Buy both and save $85!! See it mounted below!
Color Part # Pre-Order Status Shipping
#02 MHYAK-103-2
Quantity:
 
  
Coupon Code:
In Stock
$699
$179*
#06 MHYAK-103-6
Quantity:
 
  
Coupon Code:
In Stock
$699
$179*
*Quoted shipping prices: All planes are double boxed. Prices above are within the 48 contiguous states.

Click Here to see the 67" of this plane up close in our Aerobatic Plane Setup video!


103" DA-100

They tried to break the wing or fuselage and couldn't do it!


 
PHOTOS:

Color Schemes:

Color #02
Color #06
FEATURES:
- Great aerodynamic design
- Designed for precision aerobatics
- Strong, Light Weight Construction
- Instruction Manual
- Aluminum Landing gear
- Aluminum tail gear
- Professionally covered
- Large control surfaces double beveled for maximum throw
- Fuel tank system assembled and installed with fuel dot and fuel filter
- Hinges: installed


Included Hardware:
Ball Link
Fuel Tank
Aluminum Landing Gear
Aluminum Tailwheel
Tires, Axles
Servo Tray
Control linkage
Rudder control linkage
Aluminum Rudder servo arm
Push rod
Pull-pull system
Specs 103" Yak 54
Wingspan 103''
Wing Area 2046 sq in

Length

92"
Weight 25 - 28 lbs
Engine DA-85
80 - 100cc
��
NOTES:
These planes are lightweight, low cost and tough! Can't be beat.

Check out the DA-85 installed in the pictures below!


WARNING - Gasoline and Turbine powered aircraft are not manufactured to withstand unlimited G's. Any aircraft can fail, be it a wing folding up or a fuselage breaking in half under too high of a load. Just as any full size aircraft, model aircraft have a maximum G rating. Because you are not in the plane flying it and experiencing the G's and reading the G-meter, it is more difficult to judge the G's on the aircraft, and it is very easy to exceed the limits of the aircraft. Understand that if you perform a snap roll, parachute, wall, blender, knife edge loop, or pull hard on the elevator at almost any speed, you can be putting in excess of 15 G's, even in excess of 30 G's, and most aircraft can only designed to take 10-12 G's. If you perform any violent maneuver, you can break your plane. When I perform hard maneuvers, especially for the first time on an airframe, I am prepared for a failure and am prepared for it as best I can be. This mainly includes performing the maneuver far enough away from spectators that in event of a failure that I am not endangering others. In addition, be prepared for the manufacturer to not pay for a new airframe which is broken during flight. It is common practice for any manufacturer to not replace an airframe which breaks in the air or upon landing. I have only seen manufacturers replace airframes when they have received many of the same failures and the manufacturer determines that there was a design or manufacturing error. If you break an airframe, and you are the only one to do so, then it is probably not the fault of the manufacturer. Please fly safely, and avoid full throttle operation other than at low airspeeds.