*Quoted shipping prices: All planes are double boxed for added protection. Prices above are within the 48 contiguous states. 118" ships by 18-wheeler to a business address only.
They tried to break the wing or fuselage and couldn't do it!
PHOTOS:
Color Schemes:
Color #02
Color #06
FEATURES:
- Great aerodynamic design
- Designed for precision aerobatics
- Strong, Light Weight Construction
- Instruction Manual
- Aluminum Landing gear
- Aluminum tail gear
- Professionally covered
- Large control surfaces double beveled for maximum throw
- Fuel tank system assembled and installed with fuel dot and fuel filter
- Hinges: installed
Included Hardware:
Ball Link
Fuel Tank
Aluminum Landing Gear
Aluminum Tailwheel
Tires, Axles
Servo Tray
Control linkage
Rudder control linkage
Aluminum Rudder servo arm
Push rod
Pull-pull system
Specs
118" Yak 54
Wingspan
118''
Wing Area
2726 sq in
Length
105''
Weight
41 - 43 lbs
Engine
DA-150
150cc
NOTES:
These planes are lightweight, low cost and tough! Can't be beat.
WARNING - Gasoline and Turbine powered aircraft are not manufactured to withstand unlimited G's. Any aircraft can fail, be it a wing folding up or a fuselage breaking in half under too high of a load. Just as any full size aircraft, model aircraft have a maximum G rating. Because you are not in the plane flying it and experiencing the G's and reading the G-meter, it is more difficult to judge the G's on the aircraft, and it is very easy to exceed the limits of the aircraft. Understand that if you perform a snap roll, parachute, wall, blender, knife edge loop, or pull hard on the elevator at almost any speed, you can be putting in excess of 15 G's, even in excess of 30 G's, and most aircraft can only designed to take 10-12 G's. If you perform any violent maneuver, you can break your plane. When I perform hard maneuvers, especially for the first time on an airframe, I am prepared for a failure and am prepared for it as best I can be. This mainly includes performing the maneuver far enough away from spectators that in event of a failure that I am not endangering others. In addition, be prepared for the manufacturer to not pay for a new airframe which is broken during flight. It is common practice for any manufacturer to not replace an airframe which breaks in the air or upon landing. I have only seen manufacturers replace airframes when they have received many of the same failures and the manufacturer determines that there was a design or manufacturing error. If you break an airframe, and you are the only one to do so, then it is probably not the fault of the manufacturer. Please fly safely, and avoid full throttle operation other than at low airspeeds.